STERWINS 40VPS2-24.1, Инструкция по сборке, использованию и обслуживанию, Страница: 361 / 379

361
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN
Problems Probable causes Solutions
Qualifi cation
required
Product does
not start
Battery is not secure
To secure the battery pack,
make sure the latches on the
top of the battery pack snap
into place
-
Battery is not charged
Charge the battery pack
according to the instructions
included with your model
Power/speed switch is in the
OFF position
Press the on/off switch
Battery pack not properly
attached
Attach properly
On/off switch not set on ON
position
Refer to chapter “Switching
on/off t”
Chain brake is activated
Disengage the chain brake
(see section “Kickback brake”)
Product does
not reach full
power
Battery pack capacity too
low
Charge battery pack
-
Air vents are blocked Clean the air vents
Vibration
or noise is
excessive
Bolts/nuts are loose Tighten bolts/nuts -
saw chain is dull/damaged
Have it replaced with a new
one
-
Result is
unsatisfactory
Blunt saw chain
Sharpen or re-place the saw
chain
-
-
saw chain not tensioned
properly
Tension it properly
-
Product
suddenly stops
Battery pack discharged
Remove and charge battery
pack
-
Battery too hot
Remove battery pack and let it
cool down
Product maybe over
current*
Stop the product and wait for
3 minutes to restart
*Over current means "Self-protection". "Self-protection" mode is a degraded mode, limited in time (we
recommend a maximum duration of 5 minutes) during which the use of the product is made impossible
so that the product can recover its initial state.
9. END OF LIFE
Electrical products should not be discarded with household products. Used electrical products
must be collected separately and disposed of at collection points provided for this purpose.
Talk with your local authorities or dealer for advice on recycling.