stertil-KONI ST1075-FBF, Инструкции по установке, эксплуатации и техническому обслуживанию

Страница: 69 / 102

Service and troubleshooting
Operating instructions (Version 0) 69 ST 1075
7
2. Set the lever to position 2 and move the drawbar up and down; the cylinder will now
not lift if the setting is correct.
3. If the cylinder lifts, loosen nut 1 and turn the adjusting screw clockwise.
4. If the cylinder sinks down, turn the adjusting screw anti-clockwise until the cylinder
no longer sinks. Raise the cylinder to the top position and set the lever to position 1;
the cylinder should now be lowered.
5. If it does not lower, or only does so slowly, tighten the adjusting screw a little.
6. Repeat these steps until the movements at each lever position are correct.
7. Once the adjustments are correct, re-tighten nut 1.
7.7 List of parts
See appendix A "List of parts and appendices" on page 75 and appendix B "List of
parts - Options" on page 93 .
Explanation of the titles of the columns in the parts list:
Fig. & index
Fig. refers to the related group on the
parts drawing.
Index to the section in this group.
No. Total number of parts in the column lift.
Reference The numbers in this column are Stertil B.V. order numbers.
Please specify these numbers when ordering.
Description This column contains the name of the parts.
7.8 Replacement parts
You can order replacement parts from Stertil B.V. - see 1.6 "Manufacturer's details"
on page 13 for address details.
When ordering replacement parts, please supply the following information:
Column lift type:
ST 1075.
Serial number: See the type plate on the column lift.
Reference no.: See List of Parts.