14
MAINTENANCE
Filter cleaning instructions
This tap is provided with a stainless steel filters preventing foreign particles to
enter the lines. If the water flow has decreased, this may be because the filter
is clogged. The filter can be cleaned as follows:
1. For Tubular 1000 B and Tubular 1000 E: Shut-off the water shut off valve.
a. Disconnect the water supply pipes from the adaptors and disassemble
the filters from it.
b. Wash the filters under running water.
c. Reassemble the parts.
d. Restore the incoming water supplies.
e. Make sure that there is no water leakage.
2. For Tubular 1000 B Box and Tubular 1000 E Box
a. Release the screws at the panel and remove it. Turn off the regulating
valve.
b. Disassemble the solenoid valves by opening the nuts.
c. Remove the filters and wash them under running water.
d. Reassemble the filters.
e. Reassemble the solenoid valves.
f. Turn on the regulating valve and adjust the flow capacity.
g. Make sure that there is no water leakage. Re-assemble the wall cover
panel
Care and cleaning of chrome and special finishes
DO NOT
use steel wool or cleansing agents containing alcohol, acid, abrasives,
or the like. Use of any prohibited cleaning or maintenance products or
substances could damage the surface of the faucet. For surface cleaning of
faucet us
ONLY
soap and water, then wipe dry with clean cloth or towel. When
cleaning bathroom tile, the faucets should be protected from any splattering of
harsh cleansers.
If system chemical disinfection is practiced, chlorine can be used (calculated
chlorine concentration of 50mg/l maximum in water per one hour dwell time)
at service interval frequency.
