ENGLISH | 9
Before performing maintenance to the machine, always unplug the machine.
ADDITIONAL SAFETY INSTRUCTIONS FOR MITRE/TABLE SAWS
Use exclusively the type of saw blade that is recommendated by the manufacturer and complying
that meets the requirements of EN 61029-1
Do not saw any other materials than wood, wood products, aluminium and plastic.
Select the correct saw blade for the workpiece to be sawn.
Connect the dust extraction device before starting the operation.
When using the machine in the table saw position, always make sure that the riving knife has been
adjusted properly.
When using the machine in the table saw position, always use the push stick to guide the
workpiece along the saw blade.
When using the machine in the cut-off saw position, check that the upper part of the saw blade is
fully covered by the upper guard.
When using the machine in the table saw position, check whether the upper table top is tightened
firmly.
Always unplug the machine before performing any maintenance.
Do not use the machine before it has been completely assembled and installed according to the
instructions.
Do not perform any design, assembly or construction activities on the table while the machine is
switched on.
Unplug the machine and clean the table before leaving the work area.
Residual risks
The following hazards may occur during the operation of this machine:
danger of injury to the fingers and hands while changing the saw blade
danger of injury through flying debris from the workpiece
danger of hearing damage
health risk due to inhalation of airborne particles
ELECTRICAL SAFETY
Always check that the power supply corresponds to the voltage on the rating plate.
DESCRIPTION (fig. A1 & A2)
Your compound mitre / table saw has been developed for sawing wooden workpieces. The machine is
not suitable for sawing grooves, etc.
1.
On/off switch (mitre saw position)
2.
Operating handgrip
3.
Lock-off button
4.
Lock screw upper table top
5.
Dust extraction connection
6.
Lock knob bevel angle
7.
Scale for bevel angle
8.
Head lock down knob
9.
Lock knob mitre angle
10. Scale for mitre angle
11. Mounting hole
12. Lower table top
13. Guide fence
14. Saw blade guard
15. On/off switch (table saw position)
16. Lower guard
17. Guide fence
18. Upper table top
19. Upper guard
Содержание TMS210A
