Stern TMS210A, Руководство по эксплуатации

Страница: 10 / 35

10 | ENGLISH
Mounting the machine (fig. A1)
The machine must be screwed to a workbench.
Mark the position of the mounting holes (11) on the workbench.
Drill holes at each of the marked positions, adjusting the diameter and depth of the holes to the
screws used.
Place the machine on the workbench and insert the screws into the mounting holes.
Firmly tighten the screws.
Setting up the machine (fig. A1 & A2)
The machine can be set up in two operating positions: in the mitre saw position (fig. A1) and in the table
saw position (fig. A2). After use, the machine should always be left in the table saw position.
Setting up for use in the mitre saw position:
Loosen the screw (4) a few turns.
Raise the upper table top (18) while holding the head at the handgrip (2) in the lowest position.
Tighten the screw (4).
Pull out the lock knob (8).
Carefully raise the head.
Remove the lower guard (16).
Setting up for use in the table saw position:
Place the lower guard (16) on the lower table top (12).
Push in the release knob (3) and lower the head. The saw blade is fully covered by the lower guard.
Push in the lock knob (8).
Loosen the screw (4) a few turns.
Carefully lower the upper table top (18). Tighten the screw.
Adjusting the sawing angle (fig. A1 & B)
The default angle between the saw blade and the saw table is 90°.
Use a set square to check the angle between the saw blade and the table (12). If the angle does
not measure 90° adjust as follows:
Loosen the lock knob (6) and move the head so the saw blade reaches a 90° angle.
Loosen the locknut on the adjusting screw (20) and screw the adjusting screw in or out to achieve
a 90° angle. Retighten the locknut.
Tighten the lock knob.
Adjusting the bevel angle (fig. A1 & C)
The max. bevel angle is 45°.
Loosen the lock knob (6) and turn the head to the utter bevel angle.
Check the bevel angle using the scale (7). If the angle does not measure 45° adjust as follows:
Loosen the locknut on the adjusting screw (21) and screw the adjusting screw in or out to achieve
a 45° angle. Retighten the locknut.
Adjusting the riving knife (fig. D1 & D2)
Raise the head.
Loosen the screws (22) a few turns.
Adjust the riving knife (23).
Tighten the screws.