10
11
sTeP 1 - iNsTalliNg The fauceT
1.
Shut off the water supply
2.
Cut an adequate opening in the wall for the dimensions of
the D28 box, the corrugated tube, the rigid pipe and the
D28 base (where you want to install the spout).
3.
Insert the D28 box to the opening that was cut in the wall.
Connect the water supply pipe to the nipple at the bottom
of the D28 box.
4. Mount the D28 base to the opening cut in the wall and make
sure that the spout is at a 90 degree angle with the wall.
Important: The D28 base should be installed so that the
outside surface of the finished wall falls between the
minimum and maximum lines marked at the base.
5.
Assemble the rigid pipe (not supplied) from the nipple at the
box to the inlet at the D28 base.
6. Assemble the corrugated tube between the D28 base and
the box, and lead the connectors through the D28 base and
through the D28 box. Assemble the mud guard cover to
protect the D28 box.
7.
Assemble the temporary protective D28 base cover.
(See FIG.4)
8. Once the works on electricity, plumbing and tiles have been
finished, insert the wall rosette through the D28 base.
9. Cut the temporary D28 base cover and the mud guard cover
wherever required by the installation.
10. Connect the electronic unit connector coming from the
corrugated tube to the solenoid valve connector at the D28
box.
11. If your model is D28 Box E, connect the power supply
connector coming from the corrugated tube at the D28 base
to the transformer. (See FIG.5)
12. Connect the solenoid valve cable and the power supply cable
from the spout to those at the D28 base.
13. Fix the D28 spout by inserting the nipple into the D28 base.
Make sure that this area is clean before proceeding. Secure
the screw with the Allen key.
sTeP2 – coNNecTiNg The Power source
1. Remove the temporary protective cover panel.
important:
D28 is supplied with a self adjusting sensor. The ideal sensor range for
the specific location will be set automatically.
Check that no objects are in front of the
sensor besides the washbasin.
Now, remove the protective sticker that
covers the sensor.
2. If your model is D28 B Box the battery box is attached to the cover panel. Connect the
other electronic unit connector coming from the corrugated tube to the battery box
3. If your model is D28 E Box, plug the transformer into the electricity socket.
4. After you have connected the power source (battery or transformer) wait 15
seconds in order to allow the system to set the ideal sensor range. As an
indication that the self adjusting is taking place, a LED in the sensor eye will flash
continuously. The solenoid valve will be opened and closed for 1 second as an
indication that the ideal sensor range was set and the product is ready for use.
sTeP 3 – coNNecTiNg The waTer suPPly
1. Turn on the central water supply.
2. Check for leaks.
3.
Assemble the wall cover panel by screwing the four screws.
4. If the automatically adjusted sensor range is not satisfactory, please refer to the
section entitled “Settings adjustment”.
D28 BoX
D28 BoX
iNsTallaTioN
iNsTallaTioN
