Transformer
E or EM
B or BM
Swan 1000 B/E
Shut-off
valves
Filters
Flex
hoses
Filter
adapters
and
back checks
F a
u c e t i n s t a l l a t i o n
6
Step 3 - Connecting the water supply
1. Connect the red flexible pipe to the hot water supply and the blue flexible pipe to the cold
water supply.
2. Make sure that the filters and the filter adapters are installed between
the flexible pipes and the shut off
valves (not supplied).
3. Turn on the central water
supply and the shut-off valves.
4. Check for leaks.
Step 4 - Connecting the power source
1. Connect the power source:
a. For Swan 1000 B or 1000 BM: install the battery’s box at the wall under the sink using two
sided adhesive foam tape with the cable connection pointing down. Connect the connectors
(You can use an optional extension cable in order to assemble the battery box up to 10ft. away
from the sink. See section "Spare parts").
b. For Swan 1000 E or 1000 EM: Plug the
transformer into the electricity
socket and connect
the connectors.
2. For Swan 1000:
remove the sticker
from the sensor.
3. Wait a few seconds
before activating the
faucet.
4. If the range is
unsatisfactory, refer to the
section titled ”Range adjustment”.
