6
INSTALLATION
STEP 3 – CONNECTING THE POWER SOURCE
1
Remove the protective sticker
covering the sensor.
2
Connect the matching connector
from the foam dispenser body
to the compressor unit, and the
compressor unit to the pump
connector.
Please note that since the connector
is water proof, some pressure must
be applied for a prefect seal.
O-RING VISIBLE –
NOT CONNECTED PROPERLY
ONLY THE GROOVES ARE VISIBLE –
CONNECTED PROPERLY
IMPORTANT:
the 4 contacts connector should be connected properly so that the white
o-ring is not visible and a clicking sound is heard.
PAY ATTENTION:
If the 4 contacts connectors are not connected properly, the soap
dispenser pump will not operate properly.
3
Plug the transformer into the
electricity socket and connect the
transformer connector
FROM THE TRANSFORMER
TO THE SOAP DISPENSER
4
Wait about 10 seconds before
placing your hands in the sensor
range to avoid adjustment mode.
10
SECONDS
ABOUT
