Steris Basil 1100, Руководство оператора

Страница: 26 / 48

4-4
122996-004 Operator Manual Operating Instructions
To change the filling time length A or B, proceed as follows:
1. When displays shows READY or STANDBY , press FUNCTION until
display shows desired time:
A TIME
or..
B TIME
2. Press SET/SAVE once. Display will show the present time in minutes,
seconds and tenths of seconds:
0:00:0
__ Indicates flashing position.
3. To change value of the flashing digit, press FUNCTION/SELECT until
desired value is displayed.
4. Press SET/SAVE . Next digit flashes. Follow same procedure to set all four
time digits.
5. Press the SET/SAVE button to save time selection. Then, the controller will
beep three times and display will shown READY or STANDBY .
6. Once unit is in READY mode, retest fill time with a bottle rack in the fill area.
7. Repeat Steps 1 trough 6 to set B TIME .
1. Assure that ON/OFF selector switch is positioned to ON .
2. Set timer for desired fill time, depending on size of bottles. A few trials with
a basket in filling area may be necessary to determine appropriate fill time.
3. When ready, push a basket under filling head.
4. Press blue pushbutton once to fill bottles.
5. When bottles are filled, release basket from basket stopper and push basket
out of filling area.
6. At the end of shift, position ON/OFF selector switch to OFF .
7. Clean as described in Section 5, Routine Maintenance.
4.1.6 How to Change
Filling Time Settings
4.2 Bottle Filler
Operation
4.2.1 Base Units