Steris Basil 1100, Руководство оператора

Страница: 23 / 48

4-1
Operating Instructions Operator Manual 122996-004
4.1 Before Operating
Acid Proportioner
Unit
OPERATING INSTRUCTIONS
NOTE: Refer to Section 3 for component location.
1. Verify that unit shutoff valve (water) is open.
The FUNCTION/SELECT button permits the selection of the five different
functions: Priming, Water Type, Purge Time, Filling Time, and Time Settings.
To set a particular function:
1. Press the FUNCTION/SELECT button to tell the controller you would like to
set this function. The display will show the present value of the function
selected.
2. To change the selected value, press the FUNCTION/SELECT button until
the desired value appears on the display.
3. Then press the SET/SAVE button to tell the controller to save this choice.
Prime the injection pump as follows:
1. Display must show:
STANDBY
NOTE: If display does not show STANDBY , press Red STOP button and twist
to release.
2. Check to see if plain or treated water has been selected:
• Press
FUNCTION/SELECT
button. Display shows:
WATER
• Press SET/SAVE . Display will show:
PLAIN
or
TREATED
• If display shows: TREATED , press SET/SAVE again. Display will return
to: STANDBY .
• If display shows: PLAIN , press FUNCTION/SELECT . Display will
change to TREATED . Press SET/SAVE . Display will show STANDBY .
4.1.2 How to Prime the
Injection Pump
4
4.1.1 How to Set a
Function
C A U T I O N – P O S S I B L E
EQUIPMENT DAMAGE:
When choosing chemicals,
to be added to the water,
choose ones which have
low viscosity and which
have no abrasives or par-
ticles that would tend to
gum or clog the Acid
Proportioner System.