3
the collared Emitter end can r
est in a 13/16” or
7/8” hole drilled on a panel between the coils
and blower wheel on the end of unit (see photo
below).
o
Flat Plate Lamp Holder (for metal):
Connect the socket from the power supply
or extension cord to the Emitter pins. Plug
power supply’s power cord into outlet.
Reconnect power and replace outer cover
of the unit. Refer to the images below for
guidance.
o
Flat Plate Lamp Holder (for plastic)
Make a
¾” hole in the plastic external
housing or internal plastic plate in the unit.
o
Insert Lamp Holder:
Drill 1-
1/4” hole on a
panel to accommodate component A and
secure A with screws. Slide Emitter partially
through A. Slide component B (collared end
first) onto power supply
’s cord or extension
cord and install cord onto Emitter pins (see
Photo 1).
Slide Emitter and component B
through A, and twist and lock B
under A’s
tabs (see Photo 2).
o
U Bracket:
Connect the socket from the power supply to
the Emitter.
Snap the Emitter’s ceramic ends
into the spring clips of the U Bracket. Lower
the bracket and Emitter into the desired space
until the Emitter is appropriately facing the
cooling coil. Affix the bracket’s straps onto the
mounting surface with the provided hex
screws.
Component B
Component A
Photo 1
Photo 2
1.25
1.63
2.00
1.50
2.00
2.50
.81
1.62
3/4" HOLE
1.44
2.00
1-1/4" HOLE
O-RING
16
16
12 or 16
