Tech Support:
consumer.steppir.com/support | 425.453.1910 | [email protected]
12
Figure 1.15
Figure 1.17
Figure 1.16
Figure 1.18
Figure 1.19
8.
Check to be sure the terminal plug is firmly inserted into the terminal header.
9.
Cut three 1
-
inch strips of coax seal for each EHU as shown in
figure 1.15,
and place them at each end of
the wire tray of the EHU, as well as one in the center (
figure 1.16)
. This trough acts as a strain relief so
that the cable will not be pulled out of the EHU. The remainder can be used to seal the driven element/
loading coil SO239 connector and 4 conductor control cable.
10.
Lay the control cable wire inside the wire tray of the EHU as shown in
figure 1.17
. It is a good idea to
leave a small amount of slack between the plug and the point which the tray starts as shown in the circled
region of
figure 1.17
.
11.
Wrap the coax seal around the control cable as shown in
figure 1.18
. This will help keep water from en-
tering into the EHU. Repeat this process to the remaining areas of the wire tray as shown in
figure 1.19
.
12.
When finished, the EHU will be secured to the high wind reinforcing kit and optional loading coil.
WIRING