SteppIR 4 Element Yagi, Инструкция по эксплуатации

Страница: 24 / 36

Attach the Fiberglass Telescoping Poles to the Element Housing Units
The butt ends of the green fiberglass telescoping poles may vary slightly in outside diameter. Some of them
may have been sanded, while others were not. The colors at the ends will be either natural, or black. The
difference in colors has no affect on performance. Do not be concerned if they vary slightly in tightness
when being installed on the EHU’s. This is normal. All poles are tested at the factory prior to shipping, but
in the event the pole just won’t fit it is okay to sand it to fit.
The EST’s on the EHU’s have aluminum reinforcing rings attached to provide extra strength in high wind
conditions (
Figure 27 ).
Locate the eight quick disconnect boots (rubber) and repeat the following procedure for each of the eight fi-
berglass telescoping poles.
1.
Remove the black rubber shipping plug from the butt (large) end of the fiberglass telescoping pole (FTP).
2. Place the narrow end of an QDB onto the butt end of an FTP. Slide it about 6” out onto the FTP (
Figure
28 ).
SteppIR Antennas - 4 Element 24
Figure 30
Figure 29
Figure 28
Figure 27
EST
EHU