Stenhoj MAJOR 7000, Инструкция по эксплуатации и обслуживанию

Страница: 15 / 52

T61741
Revision:
14
STENHØJ MAJOR
INSTALLATION
In order to come up to your expectations now and in the future the lift must be installed in strict accordance
with the installation instructions and maintained according to our recommendations.
Contact your distributor for the name and address of the nearest authorized service shop.
FITTER INSTRUCTIONS
Install the lift in strict accordance with the original installation instructions which are included in each delivery.
The lift must be installed on solid foundation: concrete with minimum load capacity 5500 N/m² and surface
spot load under posts 350 kN/m².
Torque for expansion bolts attaching the posts: 45 N·m.
There should be sufficient light for work on and under the lift. For the lift a lighting set is available as an
optional extra comprising four impact-proof, water-tight fluorescent tubes including cable (state model
number).
Avoid installing the lift in rooms with danger of explosion.
WARNING:
Person transportation is forbidden.
OPERATION
The lift should only be operated by trained personnel !
Approach
Before driving the vehicle onto the lift, check that platforms are parallel
(the same indicator position at both ends and the two locking pins for
movable platform must be fitted).
Raising
Push UP-button
 (motor starts): raise lift to a bit above required working height.
Parking
Let go of UP-button and push PARK-button
 until platforms rest on all 4 ratchets.
Lowering
Check that no person or obstruction is under platforms. Push UP-button shortly (to release
the 4 ratchets) and then press DOWN-button
 . The lift then lowers until it reaches the
automatic anti-toe trap device and the lowering stops. Let go of DOWN-button and re-
activate it after approx. 1 sec., the lowering continues, until the lift reaches bottom position
or until pushbutton is not pressed any more.
NOTE: Always park lift (press

button) before starting to work under it.