STEMA UT04-3T-90A, Инструкция по сборке

Страница: 4 / 4

Attach the desk base assembly to the underside of the desktop using six M5*16 screws (for desktops more like 20 mm thickness):
–
2 per side bracket – 6 in total,
–
1 per crossbar end - 3 in total.
Attach the control box (6) to the middle of the crossbar, adjust the frame length with top, then covered the cable tray with
crossbar ends. Use M6*10 stighten screws. Ensure enough clearance at the wire ports for cable connections.
Double check that the wood screws are not too long for your desktop and won't puncture the surface when screwed all the way
in. We recommend that you pre-drill any holes needed for fasteners connecting. Double check that the desk base is properly
positioned on the underside of the desktop.
Connect the LC cables (P9), switch cable (7) and the power cord (P8) to the control box (6).
Use the adhesive-backed cable clips to secure the cables so they don't sag.
The switch may be placed anywhere along the front edge of the desktop but we recommend placing it toward an end so it does
not interfere with your chair when seated. Use two M5*16 wood screws to attach the switch to the desktop.
Plug the power cord into a 110 – 240 V outlet.
Make sure no obstacles are in the desk’s path.
Make sure the desktop is not touching any walls.
Make sure all cords are appropriate length to accommodate the change in height.
Important: the desk must be reset prior to use.
Reset procedure: press nad HOLD the DOWN BUTTON on the switch until the desk reaches its lowest height. Relase the DOWN
button. Press and hold the DOWN button again until the LED display „RST”. Relase the DOWN button. Press nad hold the DOWN
button again until the desk lowers a little bit more, slihtly rises and stop. Relase the DOWN button. Your desk is now ready to use.
If Your desk is not functioning properly it may need to be reset. Unplug the power cord for 20 seconds. Plug the power cord back
in and follow the RESET procedure.
Page 4 from 4