Stelrad E-VENTO 0184B0002, Руководство пользователя и инструкция по установке, Страница: 13 / 26

13
INFORMATION ABOUT PRIORITIES
BETWEEN THE DIFFERENT MODES
In Comfort, Eco and Frost protection modes, only orders of the
occupancy sensor and those of the open window sensor will be
considered.
In Auto mode, the device can receive different orders coming
from :
- 7 day and daily programming integrated (Comfort or Eco
orders);
- Open window detector;
- Occupancy detector.
Principe
In general, it is the lowest received order which prevails
- If an open window or an occupancy absence of more than 72
hours is detecting, switching to frost protection takes prece-
dence.
Special case of self-programming where the temperature level
in the room is decided according to the learning of the lifestyle
and the optimization mode selected (Opti Comfort or Opti Eco):
- During the programmed passage in Eco mode, if a presence
is detected in the room, it will be taken into account and the
appliance automatically switches to Comfort mode
- During the programmed passage to the Comfort mode pe-
riod, the absence detection system is temporarily suspended
(30 minutes).
- The Boost activation will take precedence over others orders
received.
OPTIONAL: REMOTELY MANAGEMENT BY
RF REMOTE CONTROL
• Overview
Your device can be managed by a wireless RF remote control.
Only the RF pairing procedures to operate on the controller are
described in this instructions manual.
For installing and using the remote control, refer to its instructions
manual.
1- From Frost protection mode, press for 5 seconds.
5 sec.
• RF pairing between the remote control and the
blower
The remote control and the blower are not bonded together at
the factory, then proceed as follows :
2 - The blower is in pairing mode.
Then proceed to the remote control pairing (refer to its instal-
ling and using instruction manual).
3 - When both blower and remote control are linked, the sym-
bol appears and is constantly displayed. The blower returns
automatically to the frost protection mode.
• Check the RF signal strength
You can check at any time the RF transmission performance
between the blower and the remote control.
To view the RF reception level, from Frost protection mode, press
for 5 seconds. Then the level appears on the display.
5 sec.
1 = Low RF transmission level:
To improve the RF transmission performance between the
2 devices and ensure the remotely management is opti-
mized:
- Please ensure the RF transmission is not interrupted, move
the remote control.
- Move the remote control closer to the blower.
10 = High RF transmission level, the location of the remote
control is optimized.
• RF pairing cancellation
You can cancel at any time the RF transmission between the
blower and the remote control.
From Frost protection mode press simultaniously on
and
for 5 seconds.
5 sec.
The symbol disappear from the display, the remote control
and the blower are not associated.