6
INSELN0418
The hand dryer will start automatically once hands are placed 4 inches (10cm) below the opening of the air output. The unit will shut off once the
hands are no longer below the opening.
MAXIMUM DURATION OF OPERATION
As long as the sensor detects the presence of the hands, the unit will function continuously for 60 seconds. After this delay, the user must withdraw
his hands and put them back under in order for the unit to start up again
The hand dryer will stop 1 second after no hand movement is detected
OPERATION
MAINTENANCE
TROUBLESHOOTING
N.B. In order for the warranty to be valid, the unit must be cleaned regularly.
SWITCH OFF THE MAIN BREAKER IN THE ELECTRICAL PANEL OR REMOVE THE FUSE BEFORE CLEANING THE UNIT
.
OUTSIDE
Gently wash cover (including air Inlet holes) using a soft cloth or sponge and a mild soap or detergent with luke
warm water to loosen dirt
and grime.
INSIDE
CLEANING SHOULD BE PERFORMED BY QUALIFIED SERVICE PERSONNEL
In normal use, dryer will require cleaning once a year. Heavier usage requires more frequent cleaning. Lint on the air inlet or other internal parts
of dryer will reduce efficiency and shorten the life of the working parts. To clean, remove cover by screwing the tamper-proof bolts from cover with
the special wrench provided with each dryer. Use a small, soft brush to gently clean all parts.
PROBLEM
DEFECTIVE PART OR PART TO CHECK
The hand dryer does not turn on
•
Verify that the dryer is receiving power by checking electrical service, circuit breaker or fuse
• Obstructed or defective infrared sensor
• Check for loose wires on dryer control and for foreign material on dryer sensor next to air outlet
• Check motor
• Defective control board
The hand dryer runs continuously
• Obstructed or defective infrared sensor
• Defective control board
The hand dryer does not turn on, or turns on by
itself
• Obstructed or defective infrared sensor
• Check for foreign material on optical sensor next to air outlet
• Check for loose wires on dryer control
The hand dryer blows only cool air
•
Check if Economical or Harmony mode is selected
• Check for loose connections to heating element
• Replace heating element
N.B. If you do not solve the problem after checking these points, cut off the power supply at the main electrical panel and contact our
customer service (see the “Limited warranty” section to obtain the phone numbers).
