Page 51
16400-7806 G4S REV G
15 - MAINTENANCE
The appliance is required to be inspected at least once a year by a professional service person. The compartment below firebox (behind
lower access panel) must be cleaned at least once a year, more frequent cleaning may be required due to excessive lint from carpeting,
bedding materials, or other fibrous materials. It is imperative that the burner be cleaned once a year.
A. VENT SYSTEM
•
Annual examination of venting system by a qualified agency is required.
•
IF VENT-AIR INTAKE SYSTEM IS DISASSEMBLED FOR ANY REASON, RE-INSTALL PER INSTRUCTIONS PROVIDED WITH INITIAL
INSTALLATION.
•
The flow of combustion air must not be obstructed.
B. GLASS CLEANING & REPLACEMENT
•
Clean glass only when cool and only with non-abrasive cleansers.
•
Do not operate this fireplace with glass/frame assembly removed, cracked or broken.
•
The glass assembly shall only be replaced as a complete unit.
•
Replacement of glass & frame assembly, must only be performed by a licensed or qualified service person.
DO NOT SUBSTITUTE MATERIALS.
•
Do not strike or slam glass door assembly.
VALVE AND ELECTRICAL ACCESS
There is an access panel under the floor of the firebox should more extensive service be needed. Remove the inner and outer glass
panels. Remove the glass media on the end with the pilot. The end floor lifts out; remove the screws and lift it out. Remove the burner and
loosen the pilot bracket. There is a panel under the floor you removed. Remove the 6 screws and slide the panel up.
CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER AND DANGEROUS OPERATION. VERIFY PROPER OPERATION AFTER SERVICING. KEEP APPLIANCE AREA
CLEAR OF COMBUSTIBLE MATERIALS, SUCH AS GASOLINE AND OTHER FLAMMABLE VAPORS AND LIQUIDS. VAPORS AND
LIQUIDS.
NOTE: INSTALLATION AND REPAIR SHOULD BE DONE ONLY BY QUALIFIED SERVICE PERSON. THE APPLIANCE SHOULD
BE INSPECTED BEFORE USE AND ANNUALLY BY A QUALIFIED SERVICE PERSON. MORE FREQUENT CLEANING MAY BE
REQUIRED DUE TO EXCESSIVE LINT FROM CARPETING, BEDDING MATERIALS, ETC. IT IS IMPERATIVE THAT CONTROL
COMPARTMENTS, BURNERS AND CIRCULATION AIR PASSAGEWAYS OF THE APPLIANCE BE KEPT CLEAN.
WARNING! RISK OF INJURY! DO NOT remove glass until it is cooled to room temperature. Glass breakage could occur.
See Section 6 for glass installation and removal instructions.
NOTE: IN CASE OF CHIPPED OR BROKEN GLASS
Due to the size and sensitivity of shipping the glass separately, it is best to have the replacement glass cut locally if needed.
Have your local dealer assist you with contacting Stellar Hearth Products directly to get the proper glass specifications.
Содержание 34S-20GL
Страница 2: ...INS_CUST UL REV E Page 2...
Страница 54: ...INS_CUST UL REV E Page 54...
Страница 55: ...Page 55 16400 7806 G4S REV G...
