6939500000
15
in those locations, due to conducted as well as
radiated disturbances. This equipment does not
comply with
IEC 61000-3-12
.If it is connected to a
public low voltage system, it is the responsibility of
the installer or user of the equipment to ensure, by
consultation with the distribution network operator
if necessary, that the equipment may be connected
The good operation of the machine is ensured by
correct installation; you must therefore proceed as
follows:
- Position the machine in such a way that there is
no obstacle to the air circulation ensured by the
internal fan since the internal components require
suitable cooling.
- Ensure that the fan does not send deposits or
dust into the machine.
- Avoid impacts, rubbing, and – absolutely no
exposure to dripping water, excessive heat
sources, or any abnormal situations.
MAINS VOLTAGE
The machine operates from the following mains
supply voltage(s):
IRON-MIG 303/303P
400V±15% 3P
IRON-MIG 303S/303SP
200V-575V 3P
IRON-MIG 303S/303SP
230V±10% 1P
With a Fuse rating of:
IRON-MIG 303/303P
16A 3P
IRON-MIG 303S/303SP
20A 3P
IRON-MIG 303S/303SP
32A 1P
CONNECTION
- Before making the electrical connections between
the welding machine and the line switch, ensure
that the switch is turned off .
- The distribution panel must comply with the
regulations in force in the country of use.
- The mains system must be of the industrial type.
- For longer connecting cables, increase the lead
section as required.
- When using long extension cables, the cable core
diameter size is relevant to the machine
requirements for achieving optimum performance.
- The power input supply socket from the mains
voltage supply, must have a suitable switch
provided together with a 'slow-burning' type
fuse(s).
- In the event of damage to the power cable,
replacement or repair must be performed by a
qualified person at an approved service centre.
3-PHASE CONNECTION
To connect the machine to a standard 3 phase power
source see the following scheme:
1-PHASE CONNECTION (only 303S/303SP)
This unit can be connected to input power 230 VAC 1
Phase without removing cover to relink the power
source. To do this see the following scheme:
EARTHING
- To ensure user protection the welding machine
must absolutely be correctly connected to the earth
system
(INTERNATIONAL
SAFETY
REGULATIONS).
- It is indispensable to provide good earthing by
means of the yellow-green lead in the power cable,
in order to avoid discharges due to accidental
contacts with earthed objects .
- The chassis (which is conductive) is electrically
connected with the earth lead; if the equipment is
not suitably connected to earth it may cause
electric shocks which are dangerous for the user.
LIFTING
WARNING
:
The machine weights without rolls…
IRON-MIG 303/303P
33 Kg / 72,7 lb
IRON-MIG 303S/303SP
42 Kg / 92,6 lb
