RoomPerfect™ Focus Measurement
Press
ENTER
to start the Focus position measurement. The display will ask you to place the
microphone in the listening position. Press
ENTER
once more to commence the process.
Each measurement has four steps: A low and a high frequency measuring signal, first in the left and
then in the right channel. The length of each measurement depends on a combination of the
measurement volume, set in the calibration process, and the background noise in your local
environment. Typical measuring times for the low and high frequency measuring signals are 25 and 5
seconds, respectively. You can exit a commenced measurement by clapping close to the microphone.
Do not sit in the listening position during measurement. The measurement will stop prematurely if an
error occurs during the process, and an error message is displayed. Press
ENTER
to continue and
‘Retry focus measurement – press Enter’ is displayed. If the error needs correcting this should be
done now. Then press
ENTER
to retry the measurement. The measurement procedure will start
again.
A measurement has ended successfully when the last measuring signal stops and the display shows
a RoomKnowledge rating, as ‘RoomKnowledge XX% - Measurement OK.’ Press
ENTER
to continue.
25
Содержание C
Страница 1: ...MODEL C INSTALLATION MANUAL VERSION 2 0 Skriv tekst ...
Страница 5: ...5 ...
