steinert KM 1400 SE, Руководство по эксплуатации

Страница: 8 / 11

SAFETY REGULATIONS
- The belt guard must be reclosed after each change of V-belt position, motor does not run if not properly closed
- Before the machine is switched on:
turn potentiometer to “0”,
after motor is switched o: the selected speed must be checked against the maximum permissible workpiece diameter,
- Large, out-of-balance workpieces must be machined at minimum speed,
cut them by a bandsaw octagonal to decrease out-of-balance
- All clamping levers i.e. spindle-/tailstock, tool rests etc must be tightened before beginning to work,
any operating pins /keys must be removed from chucks or spindle!
CLAMPING THE WORKPIECE
Turning between centres with the 4-prong-mandrel and live centre :
Roughly centre the workpiece at both ends outside the lathe (make bearings last longer)
that markings are visible.
Press the driver prongs firmly into the workpiece by turning the hand wheel.
Tighten the set screws for the tail stock and the quill.
Overhung turning with chucks
- Cone-shaped chuck: Taper turn the workpiece to suit the chuck diameter and drive it in with heavy blows.
- Heureka-chuck: Drive the face of the unmachined workpiece into the chuck so that the sharp edge penetrates
approx. 10-15 mm . Maximum work length 200 mm. Most suitable for soft wood.
- Face plate: Secure the wooden discs with wooden screws through the bores provided.
- Disc-chuck: Screw the workpiece into the wooden screw (if necessary, drill core hole. Wooden discs can be
used to limit the depth of penetratin of the screw).
- Jaw-chucks: Increased risk to operator with jaws which project beyond the chuck body. Remove the tightening
key before starting the machine.
- div.chucks i.e. Nova Chuck, Super Nova etc. see separate operating manual
TOOL REST
move the tool rest as close as possible to the workpiece, re-adjust it during the work. Take care of the square dimension
of your workpiece. Move tool rest just if workpiece is not turning. Clamp fastening screws.
OUTRIGGER= EXTERNAL TURNING ATTACHMENT (Option)
instruction and photo supplied if option was ordered
.
BED EXTENSION (Option)
instruction supplied if option was ordered
MAINTENANCE
The machine requires no maintenance. The ball bearings are closed-off dust-proof and must not be lubricated.
Bright parts should be oiled occasionally to prevent corrosion.
Expecially when worked with “whet” wood: clean the machine blank parts and oil them immediately
You also can use a special anti-corrosion spray like WD40 for all blank metal parts
Movable parts i.e. indexing pin, excenter shaft of tool rest, quill and spindle should be oiled (or use anti-corrosion spray)
between 4-6 month to ensure true running and prevend seizing up.
CENTERING TIP TO TIP: “0”- Point Position Headstock to Tailstock
The following parts are optional available if it is necessary to align the both tips exactly
06.200.206 extension bush MT2/MT2 x 250mm
03 900.310 cone MT2/B16
How to use it:
- fix both parts cone to cone
-
insert this “centering device” with cone into the cone of headstock