STEINDORFF NYMCS-1701, Руководство пользователя

Страница: 10 / 35

9
STEINDORFF
®
Fig 13
●
Be sure to use a GCQ-100 mercury burner.
● Be sure to mount positive pole(the wide head) before the
other , or the damage to the burner may occur.
●
Never subject the burner to excessive force when mounting
the Mercury Burner.
● Be careful and avoid leaving fingerprints or dirt on the
mercury burner. Attached stain may cause distortion in glass
which could result in a ruptured burner. If stained, wipe it a
way gently with clean gauze.
★
To prevent any hazard, always turn the main switch on the
power supply unit to “O” (OFF), unplug the power cord plug
from the mains outlet, and wait for at least 10 minutes before
replacing the burner.
2.2.8 Assembly of the Fluorescent Attachment,
Cable and Cord Connections (fig 12, 13)
1. Mount the lamp housing into the other end of the attachment
and fix it with two screws
④
.
2 ． Plug the connector ⑤ from the burner socket securely into
the connector on the power supply unit and make sure the
cord is correctly connected. (Make sure that the main switch
④
of the power supply is set to “O”
（
OFF
）
before
connecting cables)
3. Connect the power cord connector ⑥ into connector on the
power supply unit and make sure the cord is correctly
connected.
●
Verify that the voltage and the frequency of the AC mains
outlet match the setting of the voltage switch and the
frequency switch on the rear of the power supply units and
improper setting may degrade burner performance, or in the
worst case(although very rare ), cause the burner to explode.
●
It is better to use the power cord provided by BestScope and
the same type power cord should be used if you lose or
damage the old one
2.2.9 Fuse Replacement (fig 12, 13)
1 Set the main switch to “O”
（
OFF
）
and unplug the power cord
before replacing fuses.
2 Using a flat-blade screwdriver, remove each of the fuses
holders ⑦ by tuning it counter- clockwise and pulling out.
3 Replace both fuses with new ones.
●
Always use the designated fuses (8A). And make sure the
voltage of the fuse match the voltage of the AC mains outlet.
② ③
Fig 12
Fig 11
④
⑥
⑤
Voltage
Frequency