4
STEINDORFF
®
1.
Remove all parts from their packing materials and retain the packaging in case you need to transport the
product.
2.
Connect the power cord to a suitable power supply.
3.1 Basic Operation
1.
Illumination controls, see figure 3
1.1.
The power switch and transmitted / reflection
illumination toggle switch are located on the base. The
brightness control is located on the chassis. The
electrical system is fuse protected and the fuse holder
located on the power Inlet.
1.2.
Press the power switch on the side of “I”
,
which
means the circuits is got through. If the light does not
appear to be ON, check the brightness control to see if
it’s on a sufficiently low setting. Then adjust the
brightness control until image can be observed
comfortably.
1.3.
Note: Using the light at brightest setting will reduce
life span of bulb.
1
2
3
4
5
6
7
Figure 3
1.
Transmitted / Reflection Illumination
Toggle Switch.
2.
Power Switch.
3.
Brightness Control.
4.
Up Stop Knob.
5.
Focus Tension Adjustment.
6.
Coarse Focus Knob
7.
Fine Focus Control Knob
3. SETUP INSTRUCTIONS
