12
STEINDORFF
®
2.
Power on
A.
Before power on, please take out the SD card from the card reader firstly. Insert SD card into SD slot in the
right of the microscope head completely until it is locked. Push softly the inserted SD card, it will eject out,
then take it out. (When the card is under reading or writing, do not pull it out. Better power off first before
pulling out the SD card).
B.
Connect the DC plug of the power adapter to the “DC” jack on the microscope. Press the power switch
on microscope base, “WELCOME” should appear on the LCD screen. After 3 seconds, the microscope
system will be in the preview in the real time automatically when you can snap.
C.
Adjust microscope’s definition: according to its imaging focal length, make images sharp from LCD display
screen, and then the adjustment is done.
3.
Introduction of display on the LCD screen
Icons of upper left corner of Fig.23 and Fig.24 (
&
)
indicate snap (photo) mode and video mode.
On the snap mode:
Shown on the below left corner is the number of photos that
can be taken or the video recording time.
(
“766” means in the current setup mode, it still can shoot
766pcs photos
).
Fig. 23.
(“00
：
00
：
00” means in current setup mode it still can
record 00min 00sec
)
Fig.24.
When you insert SD card, the below right corner will show
this mark
.
Figure 23
Figure 24
