7
INSTALLATION
7
8
9
A
A1
A2
ADJUST THE SLIDING DOORS USING
THE SCREWS LOCATED ON THE
BOTTOM OF TOP ROLLER ASSEMBLIES.
ADJUST ROLLERS SO THAT THE
SLIDING DOORS ARE PARALLEL TO
EACH OTHER.
NOTE: DO NOT OVER TIGHTEN TOP
ROLLERS AS THIS WILL CAUSE THE
BOTTOM ROLLERS TO JAM AND BREAK
!
ALLOW 24 HOURS FOR SILICONE TO FULLY DRY
BEFORE USE.
!
A2
A3
A1
ENSURE THAT THE CHOSEN POSITION IN 1A
AVOIDS DRILLING THROUGH THE GLASS.
!
O 0.32
SCREW M4x10
CHECK FOR LEVEL
VIEW FROM INSIDE
Silicone is not used on the inside of the
shower screen because water can build
up over time within the wall channel and
leak out of the shower area. The screen
is designed to allow the water to return
into the shower area, if any is present.
SCREENS THAT ARE SEALED ON THE
INSIDE WILL VOID WARRANTY.
!
Adjust the sliding doors as shown in the illustration below.
A. Double check the frame alignment including levelling the top horizontal Rail to ensure that
the whole frame sits square on the shower.
B. From the inside attach the wall channels with M4x10 screws to the fixed glass extrusion.
C. Put bump stop covers on.
IMPORTANT NOTE:
Check detail (A1) for screw position so the glass is not touched.
Apply silicone sealer around the outside join only as diagram.
