5
B
B
B
B
B1
A1
SCREW M3.5 X 35
B1
SCREW M3.5 X 35
1
1
3
3
2
2
4
4
Note: Use lubricant on screws that fasten into top &
bottom rails. Do not use a mechanical screwdriver
as this risks seizing screw to aluminium.
Note: Apply a small bead of
silicone at joint as indicated prior
to fully fastening up. Clean off
excess.
1
2
3
Mark out the positioning of the wall profiles (refer to the Layout Plan on page 4 for measurements).
Using a soft pencil or masking tape mark out the outside boundary line on the base and up the walls
with a spirit level. Use the wall channel holes to pre-drill a 2mm lead hole in the lining.
A. Ensure the spacer blocks are in position (refer to assembly diagram on page 3, item 14).
B. Take the bottom curved horizontal rail (6) and install the two fixed panels (8). NOTE: The screw holes
in the fixed panel profiles are offset. Check that these align with the screw locations in the curved
horizontal rails. If they do not line up, change over the fixed panels. Use 3.5x35 frame screws.
Add the top horizontal rail using the M3.5 x 35 screws fasten this frame together.
INSTALLATION
Prior to wall channel fixing
Apply a continuous 7mm bead
of silicone on back of channel
plus short bead across tray to
liner join at base of channel.
A
B
B
C
C
D
D
A
A
IMPORTANT: Complete all items in 2
& 3 before intalling to wall channels
