SteelMax SM-D2, Руководство оператора

Страница: 7 / 22

7
GROUNDING INSTRUCTIONS
The d2 drill must be plugged into a three prong outlet, properly installed and
grounded in accordance with all codes and ordinances. The plug and outlet
should look like those in diagram. If in doubt of proper grounding, contact a
qualified electrician.
WARNING!
A shock hazard can result from improperly connecting the grounding wire. Do not
modify the electrical plug provided with tool. Never remove the grounding
prong from the plug. If the cord or plug is damaged, have it repaired before
using. If the plug will not fit the outlet, have a proper outlet installed by a
qualified electrician.
WARNING!
DO NOT USE STEELMAX DRILLING MACHINES ON SURFACES OR MATERIALS BEING
WELDED
.
DOING SO CAN RESULT IN PERSONAL INJURY AND
/
OR DAMAGE TO THE DRILLING
MACHINE
.
EXTENSION CORDS
Use only 3-wire extension cords that have 3-prong grounding-type plugs and 3-pole receptacles. Make sure
extension cord is in good condition. Replace or repair damaged cords. When using an extension cord, limit
length to 50ft. or less. Only use a cord of 12 gauge or larger diameter. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating. If in doubt, use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
SPECIAL INSTRUCTIONS
1.
Read and follow operator
’s manual thoroughly. Instructions are intended as a guide in safe operating
procedures and practices. Always contact SteelMax in the event any instruction is not clearly understood.
2.
Never wear loose clothing or gloves when working near cutting area or machine arbor.
3.
DO NOT touch rotating cutter or machine parts.
4.
DO NOT use dull or broken cutters.
5.
To reduce the risk of electrical shock, DO NOT remove or alter electrical panels or use machine in damp
areas.
6.
Always stop machine completely and unplug from power source before changing cutters, clearing swarf,
filling coolant reservoir or performing maintenance.
7.
Always wear eye protection. Any tool can shatter.
8.
Always use safety strap provided with machine.
9.
Always use proper tooling. Keep cutters securely fastened.
10.
Beware of ejected slugs core at end of cut. They become HOT during the cut.
11.
Keep all safety features functioning and working properly.
12.
Use only authorized service centers for repairs.