SteelMax SM-D2, Руководство оператора

Страница: 6 / 22

6
IMPORTANT SAFETY INSTRUCTIONS (
CONT
.)
13. Secure Work
• Use clamps or a vise to hold work. It’s safer than using your hand and it frees both hands to operate tool.
14. Do Not Overreach
• Keep proper footing and balance at all times.
15. Maintain Tools With Care
• Keep tools sharp and clean for better and safer performance.
• Follow instructions for lubricating and changing accessories.
• Inspect tool cords periodically and if damaged, have repaired by authorized service facility.
• Inspect extension cords periodically and replace if damaged.
• Keep handles dry, clean, and free from oil and grease.
16. Disconnect Tools Prior to Service
• Unplug when not in use, before servicing, and when changing accessories, such as blades, bits and cutters.
17. Remove Adjusting Keys And Wrenches
• Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on.
18. Avoid Unintentional Starting
• Do not carry a plugged-in tool. Always disconnect from power source before moving.
• Be sure switches are off before connecting to a power source.
19. Outdoor Use Extension Cords
• When tool is used outdoors, use only extension cords intended for use outdoors and so marked.
20. Stay Alert
• Watch what you are doing. Use common sense. Do not operate tool when you are tired.
• Do not use when taking medications that may cause drowsiness.
21. Check For Damaged Parts
• Before further use of the tool, a guard or other part that is damaged should be repaired and performance
verified prior to operation.
• Check alignment of moving parts, binding of parts, breakage of parts, mounting, and any other conditions
that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced
by an authorized service center.
• Do not use this tool if switches do not turn it on and off. Have defective switches replaced by authorized
service center.
22. Never Operate Drill In An Explosive Environment
• Sparks are generated internally by the motor brushes during normal operation.