SteelMax SM-D2, Руководство оператора

Страница: 18 / 22

18
ACCESSORY MT
2
1/2 INCH ADJUSTABLE CHUCK OPTION
The d2 drill can be used to drill blind or small diameter holes through the use of a MT2 1/2 inch adjustable
chuck option (Part # SM-DC-MT2-13). This option significantly expands the utility of the d2 drill.
To remove the standard d2 arbor and install the 1/2 inch adjustable chuck adapter, proceed
as follows:
The d2 drill cutter arbor is removable with the use of the supplied drift or
“wedge”.
CAUTION! MAKE CERTAIN MOTOR IS TURNED OFF AND UNPLUGGED BEFORE PROCEEDING.
• Turn the arbor by hand until the chuck is aligned so the Drift “Wedge” can enter slot. See photo below.
• Lightly tap end of drift wedge with a plastic mallet. Arbor should drop out easily.
• Lift the coolant bottle off the rest by lifting straight up. Store coolant bottle, coolant line and arbor.
• Align the optional 1/2 inch adjustable chuck and gently inserting it into place where the previous arbor was
installed.
• Lightly tap it into place with a plastic mallet. The chuck should remain in place
Drift
“Wedge”
Coolant Line
MT2 Arbor
Optional MT2 1/2 inch adjustable Chuck