D3X R/L / D3XS R/L
D3X R/L / D3XS R/L
Operator’s Manual
8
20. Use
the
safety chain in all operating positions. The chain must not be loose and
should be fastened to a securely fixed element by catching the chain either on
the
lugs
or
on
the
carrying
handle.
Wrap
the
chain
around
the workpiece if possible.
21. Before every use, inspect the machine to ensure it is not damaged. Check
whether any part is cracked or improperly fitted. Make sure to maintain proper
conditions that may affect the operation of the machine.
22. Always use eye and hearing protection and protective clothing during operation.
Do not wear loose clothing.
23. Operating
on surfaces with thickness
lower
than
10 mm
(0.4’’) is not recommended
as the holding force is significantly reduced.
24. The entire surface of the electromagnetic base bottom must be in full contact with
the workpiece. Before every positioning, wipe the workpiece with coarse-grained
sandpaper.
25. Do not touch moving parts or chips formed during milling. Prevent objects from
being caught in moving parts.
26. After
every
use,
remove
metal
chips
and coolant remainder from the machine.
Do not remove chips with bare hands.
27. Maintain the machine and tools with care. Cover steel parts with a thin grease
layer to protect them against rust when not in use for any extended period.
28. Perform maintenance only with the machine unplugged from the power outlet.
29. Perform repairs only in a service center appointed by the seller.
30. If the machine falls on a hard surface, from height, is wet, or has any other
damage that could affect the technical state of the machine, stop the operation
and immediately send the machine to the service center for inspection and repair.
31. Remove from the worksite and store in a secure and dry location when not in
use, previously removing the tool from the holder.
