SteelMax D1 AUTO, Руководство оператора

Страница: 7 / 23

D1
D1 Operator’s Manual
7
20. Use the safety strap in all work positions. Attach the machine to a fixed structure
by fastening the strap through the opening in the machine body or to the carrying
handle when working in horizontal position. Never insert the strap into the buckle
from the front.
21. Before every use, inspect the machine to ensure it is not damaged. Check
whether any part is cracked or improperly fitted. Make sure to maintain proper
conditions that may affect the operation of the machine.
22. Always use eye and hearing protection and protective clothing during work.
Do not wear loose clothing.
23. Proceed with caution when drilling in plates with a thickness less than 10 mm (3/8
’’)
because the holding force depends on material thickness and is much lower for
thin plates.
24. The whole bottom of the electromagnetic base must be in full contact with the
workpiece. Before every positioning, wipe the workpiece with coarse-grained
sandpaper.
25. Do not touch moving parts or chips. Prevent anything from being caught in
moving parts.
26. After every use, remove chips and excess coolant from the machine and tool.
Do not remove chips with bare hands.
27. Cover steel parts with a thin anti-corrosion coating to protect the machine from
rust when not in use for any extended period.
28. Maintain the machine and install/remove parts and tools only when the machine
is unplugged from the power source.
29. Repair only in a service center appointed by the seller.
30. If the machine falls from any height, is wet, or has any other damage that could
affect the technical state of the machine, stop the work and promptly send the
machine to the service center for inspection and repair.
31. Never leave the machine unattended during work.
32. Remove from the worksite and store in a secure and dry place when not in use,
previously removing the cutter and pilot pin from the arbor.