Steelcase RoomWizard II, Руководство по установке

Страница: 12 / 20

10 RoomWizard | INSTALLATION MANUAL
2
Remove the paper backing from the adhesive on the back of the
mounting disk. Center and level the bottom of the mounting disk
51¼ inches (130cm) above the floor using the level.
3
Attach the mounting puck to the mounting disk using the four
provided screws and a #2 Phillips head screwdriver.
4 If routing the PoE cable through an adjacent extrusion:
•
Drill a
3
/
8
-inch (10mm) hole into the extrusion.
•
Route the PoE cable through the
3
/
8
-inch hole and the mesh cable
manager.
5 Draw the PoE network cable through the mounting puck and
insert it into the back of the RoomWizard. If using the mesh cable
manager, tuck the cable manager into the housing on the back of
the RoomWizard. The RoomWizard will power on once an active
network cable is connected to the unit.
6 Using a #2 Phillips head screwdriver, attach the RoomWizard to the
mounting puck using the two provided screws. Use the level to level
the RoomWizard before tightening the screws.