REAR HOOK
OF SUSPENSION
REAR HOOK OF SUSPENSION
ENGAGED WITH REAR SLOT
OF CASE
REAR SLOT
OF CASE
1
3a
EQUAL
EQUAL
FRONT HOOK OF SUSPENSION
ENGAGED WITH FRONT SLOT
OF CASE
3b
FRONT HOOK
OF SUSPENSION
FRONT SLOT
OF CASE
Page 6 of 15
939500368 Rev K
Installation of a Drawer
Suspension
If a drawer suspension becomes
disengaged, re-install the
suspension as follows:
NOTE:
Suspensions must
NOT
be
installed with a hammer.
1.
Insert the rear hook of the
suspension into the rear slot in
the case side.
2.
Pull suspension out to gain
better leverage.
3.
Insert the front hook of the
suspension into the front slot in
the case side by rotating slightly
(3a).
PRESS DOWN
to snap the
slide into position (3b).
NOTE:
Horizontal trim may be
moved/slid from side-to-side to
center the trim if required.
