®
1a
Determine which driveshaft cover goes where, if
1
Attach Driveshaft Covers and
To maximize available space on the back of the
2
applicable. Attach driveshaft covers using four (4)
screws each, into the pre-drilled pilot holes.
NOTE: There should be about 1/4" between the
motors and the driveshaft covers.
SHORT COVER
Wire Managers
worksurface for clamping accessories, place the
wire manager over the driveshaft cover as shown.
Attach with either two (2) or three (3) screws.
No pilot holes are provided for wire managers.
LONG SIDE
SHORT SIDE
LONG COVER
TWO SCREWS
PER SIDE
ALIGN HOLES IN COVER
WITH PILOT HOLES IN
WORKSURFACE.
~
1/4"
MOTOR
DRIVESHAFT
COVER
1b
WIRE MANAGER IS
PUSHED UP AGAINST
DRIVESHAFT COVER.
BACK OF
WORKSURFACE
2
WIRE MANAGER
ROUTE SWITCH CABLE
THROUGH THIS AREA
Right-Hand Table
Shown This View)
(Equal-Sized or
Page 22 of 35
004231D Rev T
