®
Insert the exposed stud from each motor
2
Determine on which side of the table
1
Installing Motors and Synchronizing Legs
Install M6 x 80 bolts & M6 nuts to
each motor will go. (see page 8)
through the spacer, and then into the side
each motor as shown.
mounting slot of the outboard leg mounting
plates. Install M6 nut, but
DO NOT TIGHTEN
(leave motor loose).
NOTE: Install motors to outboard legs on 3-leg
tables. Do not install a motor to the center leg.
Series 5 legs and motors must be synchronized
before installing the driveshafts.
Series 5 motors are shipped from the factory in the
"all the way down" position.
Before inserting the driveshafts, ensure ALL LEGS
are pushed all the way down (fully compressed).
M6 x 80 BOLT
M6 NUT
Secondary Motor
Primary Motor
Example: Primary motor and switch
on user's right-hand side.
1
2
MOTOR
MOTOR
NO MOTOR
EXPOSED STUD
SPACER
M6 NUT
Driveshafts and Leg Synchronization
Right-Hand Table
Shown This View)
(Equal-Sized or
Page 16 of 35
004231D Rev T
