Steel City 35920, Руководство пользователя

Страница: 17 / 38

1. Remove the hex nut (K) and outer flange (J) from the
blade arbor (I). Note: The arbor has a right hand
thread; to loosen the hex nut turn it counterclockwise.
2. Place a 10 saw blade (Z) onto the blade arbor (I),
make sure the teeth of the blade are pointing down in
the front of the table saw. Place the outer flange (J)
and hex nut (K) onto the blade arbor and snug hex
nut by hand. Place the open-end blade wrench (L) on
the flats of the inner blade flange (not shown) and
the box-end blade wrench (M) onto the hex nut and
securely tighten.
Note: The blade arbor has a right hand thread, to
tighten the hex nut turn it clockwise.
"
SEE FIG.15
Fig. 16
3. Place a square (N) onto the saw blade and against the
splitter assembly (O). Make sure the splitter is square
to table
4. Lay a straight edge (R) against the left side of the saw
blade (S) Align the splitter and make sure the
splitter is aligned to the blade.
the riving knife
alignment is set at the factory. You should not need
any further adjustment. If it is necessary please refer
to the
section.
. SEE FIG.16
Note:
Riving knife to blade adjustment
SEE FIG.17
Fig. 17
5. Replace the table insert and tighten the table insert
retaining bolt removed instep 1.
6. Always check the blade guard and anti-kickback
fingers before using the saw to make sure they
operate freely and don't bind.
Riving knife to blade adjustment
1. Riving knife to blade clearance: the gap between
The riving knife and the saw blade should be an even
distance across the entire radius. SEE FIG 18
.
Fig. 18
2. The riving knife should also be in line with the saw
blade. If adjustment is necessary:
1) Locate the riving knife clamping block assembly.
2) Loosen the (2) 5 MM Socket head cap screws slightly
enough to move the bracket bringing the riving knife in
line with the saw blade making sure the gap between
the blade and knife is even and from 1/4 to 5/16“ in
Distance.
3) Once the riving knife is aligned with the blade, tighten
the (2) 5 mm Socket head cap screws up
SEE FIG.21
.
Fig. 19
21