Page 18
15. Re-check the height setting on all knives and re-set if
necessary.
16. Replace the fence and the cutterhead guard and set
the infeed table height. Do not touch the outfeed table
adjustments.
WARNING
!
MAKE CERTAIN THAT ALL KNIVES ARE
SECURELY FASTENED IN THE CUTTERHEAD
BEFORE TURNING ON THE POWER.
HELICAL CUTTERHEAD INSERT
REVERSAL / REPLACEMENT
MODEL 30-200 H:
1. Using one of the supplied Allen keys, loosen but do not
remove the nut and screw
A
and remove the knife
holder/chip breaker
B
and the insert C.
(Fig. 35)
2. Thouroughly clean the housing
D
before reinstalling the
knife holder/chip breaker and insert.
(Fig. 36)
3. Thouroughly clean the knife holder/chip breakers
E
and
inserts
F
using a lacquer thinner and a small brush.
(Fig. 37)
4. Reverse or replace the insert and re-install it along with
the knife holder/chip breaker into the slot and partially
retighten the nut and screw
G
.
Fig. 35
Fig. 36
Fig. 37
Important! To prevent knife height
discrepancies, the knife holders /
chip breakers and inserts must be
clean and free of debris.
5. Center the knife holder/chip breaker with the flat
edge of the nut
H
and fully tighten the nut and
screw.
(Fig. 38)
6. Repeat with all the other inserts.
Fig. 38
IMPORTANT:
DO NOT REMOVE the nut and screw that secure the
knife holder/chip breaker, ONLY LOOSEN. If the nut
and screw have to be replaced or if they have been
removed, follow instructions below to make sure the
knife holder/chip breakers are all secured at the same
height into the cutterhead.
1. Place the screw in the threaded hole but do not start
tightening it yet.
2. Place the nut on top of the screw but do not start
tightening it yet.
3. Hold the nut with your fingers and tighten the screw.
This will tighten both the screw and the nut simultaneously.
Do not thread the nut onto the screw before tightening
the screw into the threaded hole in the cutterhead.
