Steba Steambaker DG3, Инструкция по эксплуатации

Страница: 13 / 14

12
6. Steam cleaner shall not be used.
7. Cleaning the door seal constantly. Use a soft cloth and soap water then wipe it with dry soft cloth.
8. If control panel is wet, wipe with a soft dry cloth, do not use abrasive cleaning agent to wash it. The door
should be opened when washing control panel to avoid activating the oven.
9. If not used for a long time, plug off the oven and placed in a dry airy place with no caustic gas.
10. If malfunction occurs, it must be repaired by qualified serviceman from the manufacturer; it is dangerous for
any other person to attempt to repair it.
11. The oven must be plugged off before replacing the lamp .the lamp must comply with requirement: 20W
，
120V with temperature resistance of 300
℃
and VDE socket.
12. Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass or food tray since
they can scratch the surface.
13. Steam cleaner shall not be used.
14. Do not clean the oven cavity immediately after a cooking ends; wait for 30 minutes so the cavity and heaters
have cooled before cleaning.
Problem-shooting
Problems Possible causes Problem solving
Dark display window
Oven is not connected and
the power cord does not work
properly
Make sure oven is connected
(fuse is in place)
Contact the after sales service
Lamp does not work
Lamp, fuse not comply
standards,
Lamp does not connect to
power.
Replacement of lamp
Connect the power cord
properly
Change the fuse
During cooking, water or
water vapor leaks out from the
door.
Door does not close properly
Door seal is damaged
Contact after sales service
Code Analysis Solution
E-1
Cavity high temperature protection: more
than 240°C
Stop to cool down.
E-2
Cavity low temperature protection:
cooking 3 min. 40°C
Contact service. User should
not disassemble.
E-3 Heating plate protection: more than 240°C Stop to cool down.
E-4
Heating plate: after 3 min. Cooking, temp.
less than 40°C
Contact service. User should
not disassemble.
E-5 Heating plate sensor protection
E-6
Heating plate sensor short circuit
protection
E-7 Cavity open circuit protection
E-8 Cavity sensor short circuit protection
Contact service professional
user should not disassemble
the oven.
E-9
Signal malfunction protection after 30-40
sec. No signal checked
Check if the water tank is
placed well or water is enough.