9 |
P a g e
Rev 10/2012
6.
The wires for the fan, speaker, and light are labeled.
Make the corresponding connections from the
accessory to the wire coming from the control box.
*Note: Be cautious when making this connection. The
pins of the connector can easily bend if connected
improperly!
A: Wire for control panel
B: Temperature Sensor
C: Wire for speaker/fan/light
D: Speaker
E: Fan
F: Lights
G: Connecting terminal for
light/fan/speaker
H: Control panel connecting
terminal
7.
Install the angle bracket to the holes on glass B (black
back panel). Connect with screw. Tighten snugly, but
leave enough tension to adjust. Insert the corner seal
on the on the left side of glass B.
Note: Attach glass shelf brackets to back of panel
before proceeding.
8.
(MA6020, MA6027& MA6028)
NOTE: Attach glass
shelf brackets to the holes in glass B.
9.
Place the bottom edge of glass B into the slot on the
base as shown below. Align the holes and connect
with angle brackets. Connect to glass A.
10.
Insert the corner seal to the right edge of glass C, then
install angle brackets to the glass panel (C). Tighten
snugly, but leave enough tension to adjust. Refer to
picture below. Install glass shelf brackets on panel C
before moving forward
11.
Place glass C into the slot onto the base and insert into
the corner seal of glass B. Note: Glass B is the black
panel, and glass C is a black panel. Line up the
installation holes and connect glass B and glass C.
12.
Assemble the half-moon shaped seals on the sides a,
b, and c of glass D (top). See illustration below. Attach
angle brackets to glass panel D.
A
C
B
