Page 11 of 13
24.
Locate ground stud on driver
side of vehicle. Trim white
ground wire so it will reach
ground without excess wire.
Crimp the supplied fork
terminal to the ground wire.
Connect the ground wire to
the stud using the supplied
M6 nut.
NOTICE: Add supplied nut on top
of vehicle nut, so vehicle wiring
does not lose ground.
INSTALL WIRING KIT
CONTINUED
25.
The power wire will need to
be routed to the engine
compartment where it will
connect to the battery. Route
the wire from the rear of
vehicle to the gravel guard on
the driver side undercarriage.
Loosen the (5) nuts holding
the gravel guard to allow
routing through it. Then pass
the wire up into the engine
compartment.
26.
Uncover the vehicle battery.
Locate the fuse holder
supplied in the wiring kit box.
Remove the fuse from fuse
holder. Trim excess black
power wire length. Crimp fuse
holder lead to power wire.
Connect fuse holder ring
terminal to the positive
battery terminal (+).
