Stealth Cam stc-g26ng, Инструкция по эксплуатации

Страница: 15 / 59

www.stealthcam.com Page
877-­‐269-­‐8490
15
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
§ PIR DELAY – 00min 05sec (default): This setting is used to determine the length of
the time that the camera will wait before it reinitializes its PIR sensor for the next
activation. With the TL mode this setting is only active if TL Delay is set to 1 min or
greater. This setting can be changed between the numbers of 00min 05sec to
59min 59sec. With this option blinking, use of the UP and DOWN arrows will allow
the minutes setting to be changed from 00 to 59. Once this setting is on the
appropriate minutes, press the RIGHT arrow key to move to the seconds setting
and it will start to blink. Use of the UP and Down arrows will allow the seconds
setting to be changed from 00 to 59 (05 to 59 if minutes = 00).
§
TL DELAY – 00min 30sec (default): This setting is used to set a delay between TIME
LAPSE images. This setting can be changed between the numbers of 00min 05sec to
59min 59sec. With this option blinking, use of the UP and DOWN arrows will allow
the minutes setting to be changed from 00 to 59. Once this setting is on the
appropriate minutes, press the RIGHT arrow key to move to the seconds setting and
it will start to blink. Use of the UP and Down arrows will allow the seconds setting
to be changed from 00 to 59 (05 to 59 if minutes = 0). If the TL Delay is greater than
or equal to 1 min, then the PIR sensor will be active between time-­‐lapse photos.
•
TL START – 06:00PM (default): This setting is used to give the camera the start time
for when to start the time-­‐lapse photography. The default format is in a HH/MM/AP
setup, should the time format be in 24 hour the format it
will show HH/MM. With the HH (hour) setting blinking, use the UP and DOWN
arrows to allow the setting to be changed from 1 to 12. Once this
setting is on the appropriate hour, press the RIGHT arrow key to move to the MM
(minute) setting and it will start to blink.