www.ecomposter.net
B
C
You MUST lift the handles on each side of the outer lid to
install to the sphere. Lining up pegs inside the lid with large
hole in the openings in the collar, set the lid into the collar
and turn clockwise until the pegs reach the end of the
openings. Lower the handles to lock in place.
Turn the sphere over and repeat step A and B to install the cover
on the other end. Use the included key or your hand to turn the
inner lid counter-clockwise and lift to open.
A
Install Lids
Step 10:
Components:
L1 x 2
Outer Lid
L2 x 2
Inner Lid
L3 x 1
Key
You MUST lift the handles on the outer lid to install
to sphere. DO NOT LIFT sphere using the handles.
!
NOTE: If the cover does not turn easily, use a Phillips
screwdriver to loosen the screws on the pegs inside.
Lining up pegs inside the inner lid with large holes
in the outer lid, lower the lid into place. Use three
fingers to turn clockwise to close the lid.
11 of 18
View from Inside
Pegs on outer lid slide to the
end of the opening in collar.
To remove rubber plug in the center of the inner lid to
drain liquids, remove inner lid from outer lid. From inside,
pinch rubber plug together and push through the hole
in center of inner lid. Keep the rubber plug in a safe place,
until you are ready to insert back in.
