The diagram below describes how to move around the menu structure and enter data. More specifically it
details:
1. How to enter a real number
2. How to choose an option from a list
3. How to enter and navigate around a submenu
Using these three procedures the user can enter all applicable data to configure the unit to suit the application.
The options displayed depends on whether the short menu or full menu option is enabled (This can be
selected in the
SYStEn
submenu).
This menu configures the unit to suit the application. The menu covered in this section is the menu structure
for all applications.
The ‘Menu’ mode is protected by a passcode and the user is asked for this when the ‘Menu’ mode is
accessed from the run mode. The passcode is set to the default of 0 and can be changed to any value
between 0 and 65535, setting the value to zero (default) removes the passcode prompt and the passcode
function is disabled.
If enabled this
gives access to
the relevant
alarm setpoints
To revert to ‘Run’
mode, press these
keys up to 4 times
Show electrical
value e.g.
(4 to 20) mA input
Shows secondary
value i.e.
total or rate
If enabled this will
clear total, and/or
latched alarms
Perform clear
function
Show upper 6
digits of Total
RUN MODE
(RATE OR TOTAL DISPLAYED)
Edit setpoints
menu shortcut
Followed by
Enter menu mode
8.2 RUN MODE OPTIONS
9.0 MENU MODE
9.1 GENERAL MENU NAVIGATION
Cycle around menu items
IIttEEn
n 11
Description
IIttEEn
n 2
2
Description
IIttEEn
n 33
Description
1. Entering
a number
2. Choosing
from
option list
3. Entering
a submenu
Enter Value
11 2
2 33 4
4 5
5 6
6
o
oP
Ptt A
A
o
oP
Ptt B
B
Description A
Description B
IIttEEn
n 33A
A
Description 3a
IIttEEn
n 33B
B
Description 3b
Shift into
editable values
Shift into
editable values
Shift into
editable values
Escape to reject
change
Cycle around menu
items
Shift into
editable values
Escape to reject
change
Escape to reject
change
Inc to increment
digit
Inc to increment
choice
Enter to
accept change
OR
Enter to
accept change
OR
Page 12
Page 11
