STATESMAN XR714W, Инструкция по эксплуатации

Страница: 8 / 20

8
Connecting the drain hose
• Fit the drain hose ensuring that it is 65 – 100cm above the floor;
otherwise it could cause poor drainage.
• Connect the drain hose support bracket to the drain hose and
place drain hose into the drainage pipe.
Important: Do not put the drain hose more than 30cm into the
drain pipe and the drain hose cannot be immersed in water
otherwise the appliance will not operate correctly.
OPERATING INSTRUCTIONS
Before using the appliance for the first time you must run a complete cycle without clothes, this will
remove any water which was left from the manufacturers test runs; follow below steps;
• Put a small amount of detergent into the drawer and close.
• Press the On/Off button .
• Turn the control dial to the “Cotton” setting.
• Press the Start/Pause button .
Sorting Clothes
• Do not overfill the appliance above the load capacity.
• Garments should be sorted by colour and care label, most garments have a textile care label in
the collar of side seam. Do not wash dark colours with whites or light colours as this may
stain the garments.
• Make sure that all garments have no foreign
objects left in pockets.
• Close any zips, fasten hooks etc. before washing.
• Soiled and stained garments should be pre-treated with
stain removers etc. before washing.
• For garments that have a woollen surface or are prone to
pilling, turn inside out to help protect.
Detergent
• Pull out the detergent drawer.
• If doing a pre-wash add detergent into compartment (I).
• For a main wash add detergent into compartment (II).
• If required add fabric softener into compartment .
Important: Care labels should be checked before adding
softener to wash.
• Do not add detergent above the maximum suggested levels.