The instructions must be followed, otherwise the gu arantee is invalid.
LPG CONVERSION
This cooker has been pre-set for use on Natural Gas. A conversion kit is included for
converting the appliance for use on LP Gas. This should only be carried out by a suitably
qualified engineer.
CHANGING THE I NJE CTORS
Refer to the table of injector sizes to select the correct injectors. The hotplate injectors are
situated underneath the hotplate caps. To access the oven and grill injectors, proceed as
follows:
1.
Remove the outer back panel. Unscrew the gas supply tube nut from the injector
block.
2.
Remove the oven base panel inside the oven.
3.
Remove the 2 screws at the rear, either side of the oven burner to release the
oven injector block behind.
4.
Replace the injector with the relevant LPG one and re-fit the injector block.
5.
Remove the grill burner by undoing the screw at the front of the burner.
6.
Exchange the injector without removing the injector block and re-fit the grill
burner.
SETTING THE SIMME R RATE S
HOTPLATE BURNERS
;
Switch off the electricity supply and access the burner by-pass screws as follows;
1.
Remove the hotplate tray by undoing the rear fixings and the 2 small screws
beneath each hotplate burner head. Now slide the hotplate forwards to unhook it
from the front locators.
2 .
Unscrew and remove the control panel, taking care with the ignition switch wires.
3.
The by-pass adjustment screw can now be accessed and adjusted as necessary.
4.
Carry out the oven adjustment before re-assembling.
1 2
