STATESMAN BIC5050S, Инструкция по эксплуатации

Страница: 6 / 20

6
INSTALLATION
Before installing your appliance, you should pay attention to the following points:
• Operating voltage for your appliance is 220-240 V at 50Hz. Before making the connection to the
power supply, ensure that the voltage on the nameplate corresponds to the voltage of electrical
system in your home.
• The plug must be accessible after installation. If the socket has no earth contact or the plug does
not match, we suggest calling an authorized electrician for assistance.
• There may be an odour when you first switch on the appliance. It will disappear after the
appliance starts to cool.
• We do not take responsibility for damages that occur due to use on installation with no earth.
• Your appliance should be at least 50cm away from stoves, Gas ovens and heaters, and should
be at least 5cm away from electrical ovens. Do not place heavy items on the appliance.
• Clean the appliance thoroughly, especially the interior, before use (See ‘Cleaning and
Maintenance’ on page 13).
• This product is intended to be used in proper kitchen units only.
• The adjustable front legs should be adjusted to make sure your appliance is level and stable. You
can adjust the legs by turning them clockwise (or in the opposite direction). This should be done
before placing food in the fridge.
• Install the plastic distance guide (the part with black vanes at the rear) by turning it 90° as shown
in the figure to prevent the condenser from touching the wall.
• The appliance should be placed against a wall with a free distance not exceeding 75mm.
Installation Procedure
• Before installation, read the instructions carefully.
• Fit the refrigerator/freezer in suitable kitchen units only.
• If necessary, reverse the door according to instructions.
• Check the installation dimensions according to fig.C. The position of the joint between the unit
doors must be level with the position of the joint between the appliance doors.
1) See fig.A for the necessary attachment components:
fig.A:
Top Fixing Bracket
Trim Gasket
Guides
Rails
Screw Type A
Screw Type B