SV1110IPEXT Instruction Guide
5
Follow these instructions if the host computer uses a USB keyboard and mouse:
IMPORTANT:
Not all computers fully support USB mice and keyboards and recognize
them on startup. It is strongly recommended that you test the USB devices you will use
with the host computer before configuring the SV1110IPEXT. If the computer does not
work properly with USB devices, you can attempt to update the computer’s BIOS to the
most recent version to see if it adds USB input device functionality. Consult your
computer manufacturer for details.
1.
Power down the computer to which the SV1110IPEXT will be connected (the
“host computer”). If purchased, install the unit in your rack or cabinet following
the instructions that came with the 1110EXTRACK (optional, not included).
2.
If present, disconnect the existing monitor and USB keyboard/mouse from the
host computer.
3.
Using the provided integrated KVM cable, locate the end with the
male
VGA
(monitor) connector and connect it to the VGA-out connector on the back of the
host computer.
4.
Insert the VGA connector on the opposite and of the integrated KVM cable to the
Video (IN)
port on the rear panel of the SV1110IPEXT.
5.
Connect a USB Type A to 5-pin mini-B cable to the
USB
port on rear panel of the
KVM.
6.
Connect the opposite end of the USB Type A to 5-pin mini-B cable to an
available USB port on the managed computer.
7.
Using a Category 5 Ethernet patch cable, connect the
LAN
connector on the rear
panel of the SV1110IPEXT to a network data jack (usually on a hub, switch,
router, or pre-wired wall jack).
8.
Optional:
If needed, connect the
WAN
connector on the rear panel of the
SV1110IPEXT to a network data jack (usually a hub, switch, router, or pre-wired
wall jack).
For more information on the WAN port, please refer to the
section “Configuration Methods Explained” on page 7 for important
information.
9.
Important:
If you want to continue to use the host computer locally, skip steps
10 and 11 and go directly to “Connecting a Local Keyboard, Mouse, and
Monitor” below. Otherwise, complete steps 10 and 11 now and continue to
“Configuration Methods Explained” on page 7.
10.
Connect the power cord (provided) into an appropriate electrical outlet, plug the
opposite end of the power cord into the AC/DC adapter, and plug the power
connector into either the
DC-in
or
DC-in-2
port on the rear panel of the unit.
The LED underneath the power connectors will be solid green when the unit is
powered.
11.
Power on the host computer.
NOTE:
If you are using cables other than those provided in the SV1110IPEXT package
or branded by StarTech.com, ensure that the cables are of high quality and use the
minimum possible distance necessary. Low quality or excessively long (particularly
