4
eSATA Controller Card Installation (S352U2RERC only) - PEXESATA1
There are two SATA ports available on the PEXESATA1 card - one
internal (SATA) and one external (eSATA). Please note that only one
of them will work at a time. Using the jumper settings provided above,
please designate which port is to be used. By default, Port 2 (internal)
is set to active.
Turn your computer off and any peripherals connected to the
1.
computer (ie. Printers, external hard drives, etc.). Unplug the power
cable from the rear of the power supply on the back of the computer.
Remove the cover from the computer case.
2.
Locate an open PCI Express slot and remove the metal cover plate
3.
on the rear of the computer case. Note that this card will work in PCI
Express slots of additional lanes (ie. x4, x8 or x16 slots)
Insert the card into the open PCI Express slot and screw the bracket
4.
to the rear of the case.
JP
Action
Setting
J1-J4
Enable external
eSATA port
Set J1-J4 jumpers to pins 1 and 2
Enable internal
SATA port
Set J1-J4 jumpers to pins 2 and 3
eSATA
SATA