Instruction Manual
4
4. Place the side panel back onto the enclosure, making sure to properly line up the
latches before snapping the cover into place.
AP Mode Setup
In this mode, the WiFi Enclosure will act
as a wireless access point (AP), enabling
computers with wireless adapters to
connect to it. All connected clients will then
be able to access the resources of the WiFi
Enclosure. The WiFi Enclosure can also be
connected directly to an Internet enabled
router/switch/broadband modem to share
Internet access to all connected clients.
1. Make sure the Mode Switch on the rear
panel of the enclosure is set to “AP” mode.
2.
OPTIONAL:
Connect an Ethernet cable from the enclosure to the Ethernet port on a
router/switch/broadband modem.
3. Connect the included power adapter to the enclosure.
4. Extend the flip up antenna, located along the top edge of the enclosure.
5. Press the power button located along the top edge of the enclosure, near the
rear panel. The LEDs on the front of the enclosure will light up and begin flashing
orange during initialization. Once the Power LED lights up solid green, the unit will
be ready.
NOTE:
The default wireless network name (SSID) is “S2510U2WF”, with an IP address of
192.168.2.1. Automatic IP (DHCP) is also enabled.
Modem /
Router
Computer