StarTech.com PCI555WG, Инструкция по эксплуатации

Страница: 12 / 16

10
recommended.
1/2/5.5/11/6/9/12/18/24/36/48/54Mbps:
Forces the card to use only the transmission
speed selected. If Wireless Mode is set to
802.11 B only
the only speeds available for
this setting will be
1/2/5.5/11Mbps
. Note that the ability to make a successful
connection at a particular speed is affected by both distance and environmental
interference. If you select a value that is too high for the current environment and
location, the wireless connection may be intermittent or fail.
Turn Off RF Button: When clicked, this will temporarily disable the wireless connection.
Click again to re-enable the PCI555WG.
Once you have finished adjusting your settings, click
Apply
to enable them. Note this
may cause a short disruption with your wireless connection as the card re-connects to the
access device using the new settings.
About
This tab displays general information about
drivers and software you installed with the
PCI555WG, and well as information about
the card including EEPROM version and
MAC address.
Troubleshooting
This section addresses common problems with wireless connections. Please examine this
section and attempt the solutions offered before contacting technical support. Given the
complexity of some wireless networks, you may want to get assistance from your System
Administrator or other professional if you encounter difficulties achieving a stable,
secure wireless connection.
Problem:
I cannot connect to my wireless network.
Cause:
Your security and/or encryption settings may not match those of the wireless
access device (router, access point) to which you are trying to connect, or there
may be an environmental issue (distance, interference) that is compromising
the connection.
Solution:
1) Go to the
Statistics
tab of the Configuration Utility. If a signal is present but
extremely low, try reorienting the antenna of the PCI555WG or decrease the
distance between the antenna and the access device to improve the signal
strength.
2) If there is a great deal of potential interference-causing material between the
antenna and access device (electrical cables, heavy machinery, solid walls) you
may wish to relocate the computer or access device.
3) Ensure that the Tx Rate is set to
Auto
on the
Advance
tab in the
Configuration Utility so that the card will negotiate the best possible